Xerox DocuPrint N2025 System Administrator Manual page 189

Table 5.1 Control Panel Messages (continued)
Message
Open Offset Door
Clear Paper Path
Open Rear TrayDr
Clear Paper Path
Out of Memory
Paper Jam-
Open Top Cover
Paper Size Jam-
Open Rear Cover
Please Wait
Power Saver On
Print Using
<size> <type>
Explanation/Corrective Action
Part of a sequence of messages following an initial paper jam message.
Open the Offset Catch Tray's rear door, clear any jammed paper there,
close the covers, then refer back to the Control Panel for further messages.
Part of a sequence of messages following an initial paper jam message.
Open the 2,000 sheet feeder's rear door and remove any jammed paper
jam, close the covers, then refer back to the Control Panel for further
messages.
The printer is out of memory while processing a job, and will resume
printing when memory is freed up. Partial pages may be printed.
A paper jam has occurred inside the top cover. Open the printer's top
cover, then refer back to the Control Panel for further messages.
The size of the paper fed into the printer was not the size expected by the
printer, causing a jam. Load any tray with the size requested in the job
printing. Check the multi bypass feeder size menu to confirm that the
setting reflects the size currently loaded in the MBF. Open the printer's rear
cover, then refer back to the Control Panel for further messages.
An operation that takes time is proceeding. Please wait until the operation
finishes and the display changes.
The printer is in Low Power Mode.
A job is printing on a paper size or type that does not match what was
requested. If the paper size and type that was substituted is not
acceptable, load the requested paper size and type and print the job
again.
Control Panel Messages
Table 5.1 Page 7 of 10
Chapter 5: Troubleshooting 5-11