Disk Drives; System Disk Drive - Intergraph StudioZ GT RAX System Reference Manual

To replace the disk drive bay door, you must first remove the top cover and open the face panel.
To replace the face panel, you must remove the top cover and the disk drive bay door.
To replace the top cover:
1. Remove the top cover. See Chapter 1, "Accessing the Components," for details.
2. Install the new cover.
To replace the disk drive bay door:
1. Open the face panel. See Chapter 1, "Accessing the Components," for details.
2. Remove the two hinge screws attaching the door to the face panel.
3. Remove the door.
4. Position the new door so that the screw holes on the door are aligned with holes in the face
panel.
5. Replace the two hinge screws, ensuring that the hinge screws are equally tightened. This will
ensure that the door is centered properly.
To replace the face panel:
1. Remove the disk drive bay door from the old face panel as described previously.
2. Install the disk drive bay door in the new face panel as described previously.
3. Remove the old face panel by removing the two shoulder screws at the bottom left and right
corners of the face panel.
4. Align the bottom of the new face panel with the front of the unit, and reattach the two shoulder
screws from step 3.
5. Close the new face panel. See Chapter 1, "Accessing the Components," for details.

Disk Drives

This section explains how to replace the CD-ROM drive and the various disk drives in the system.
See Chapter 7, "Peripherals," for details on drive configuration and cables.

System Disk Drive

The system disk drive is located in the uppermost part of the peripheral device bay, above the
CD-ROM and floppy disk drives, as shown in the following figure.
9