Intergraph InterServe 650 ?anual Supplementary Manual
Late-breaking news
Hide thumbs
Also See for InterServe 650 ?anual:
- Setup manual (94 pages) ,
- System reference manual (132 pages)
Related Manuals for Intergraph InterServe 650 ?anual
Summary of Contents for Intergraph InterServe 650 ?anual
- Page 1 InterServe 650, 660 Late-Breaking News June 1998 DHA0203G0...
- Page 2 Notice Information in this document is subject to change without notice and should not be considered a commitment by Intergraph Computer Systems. Intergraph Computer Systems shall not be liable for technical or editorial errors in, or omissions from, this document.
- Page 3 General Setting Up Your System for the First Time When setting up your system for the first time, you should do so as follows: Set up the basic system hardware as described in the system documentation. However, do not connect any external peripherals to the system’s SCSI ports. Start the system and complete operating system Setup as described in the system documentation.
- Page 4 Do one of the following, as appropriate: Change the value to Enabled to limit memory use to 2 GB. Change the value to Disabled to use all of the system’s memory. Save the change and exit from BIOS Setup. Restart the system. You can also reset the BIOS to Optimal to use all of the system’s memory.
- Page 5 Controllers PCI Slot Order Power Console BIOS Configuration 0 (Boot) Booting a System with RAID Controllers InterServe 650 and 660 are shipped with RAID disk array controllers installed in PCI slots 4 through 7 (in ascending order). The RAID controllers should remain in these slots. On a system with one RAID controller, the controller is installed in PCI slot 4.
-
Page 6: Inserting A Power Supply
Inserting a Power Supply When inserting a power supply into a running InterServe 650 or 660 (for example, when replacing a failed power supply), push the supply completely into the system. Once the supply is fully seated, close the extraction lever. If the supply does not power on, simply pull the power supply out, wait at least 45 seconds, and push it back into place. -
Page 7: Installing Qfe Software
Windows NT 4.0 Installing the Adaptec SCSI Controller Driver If you have to reinstall Windows NT 4.0, be sure to reinstall the driver for the SCSI controller (2940 ) from backup diskette during Setup. SCSIDRV To install the 2940 driver during Setup: SCSIDRV When prompted, press to bypass detection of mass storage devices.