Cr_Keydis Command; Cr_Security Command; Cr_Pjlocknow Command; Cr_Pjlockmenu Command - Sanyo PLC-XM100/L - 5000 Lumens Manual

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications

9.11.25 CR_KEYDIS Command

Command "CR_KEYDIS" [CR]
Details Get status of RC/KEY (valid or invalid)
Acceptable
Response
%1
Unacceptable

9.11.26 CR_SECURITY Command

Command "CR_ SECURITY" [CR]
Details Get ON/OFF setting status of Security on menu.
Acceptable
Response
%1
Unacceptable

9.11.27 CR_PJLOCKNOW Command

Command "CR_PJLOCKNOW" [CR]
Details Get actual setting status of PIN code lock
Acceptable
Response
%1
Unacceptable

9.11.28 CR_PJLOCKMENU Command

Command "CR_PJLOCKMENU" [CR]
Details Get ON/OFF setting status of PIN code lock on menu
Acceptable
Response
%1
Unacceptable

9.11.29 CR_SHUTRCPROT Command

Command "CR_SHUTRCPROT" [CR]
Details Get status if Shutter can be controlled by R/C
Acceptable
Response
Unacceptable
"000_%1" [CR]
"NONE" -------------------------- RC and KEY, both are valid
"RC" ------------------------------- RC is invalid
"KEY" ----------------------------- KEY is invalid
"Error Code" [CR]
"000_%1" [CR]
"ON" ------------ PJ is locked
"OFF" ----------- PJ is not locked.
"Error Code" [CR]
"000_%1" [CR]
"LOCK" ------ PJ is locked
PIN code lock is set to ON1/ON2 on the menu and PJ PIN
code is not entered, therefore PJ is actually locked.
"FREE" ------- PJ is unlocked (either A or B)
A) PJ lock is set to OFF on the menu
B) PJ lock is set to ON1/ON2 on the menu, but PIN code
Lock mode is released because PJ PIN code is entered.
"Error Code" [CR]
"000_%1" [CR]
"ON1" -------------------- PIN code lock ON 1 is set on the menu
"ON2" -------------------- PIN code lock ON 2 is set on the menu
"OFF" -------------------- PIN code lock OFF is set on the menu
"Error Code" [CR]
"000_%1" [CR]
"ON" -------------------- Shutter is not controllable by R/C
%1
"OFF" ------------------- Shutter is controllable by R/C
"Error Code" [CR]
75/79