Image Command; Cf_ Bright Command; Cf_Cont Command; Cf_Color Command - Sanyo PLC-XM100/L - 5000 Lumens Manual

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications

8.4 Image Command

8.4.1 CF_ BRIGHT Command

Command "CF_BRIGHT_%1" [CR]
"000-063"--------------- Directly specify setting value of Brightness
%1 "UP"--------------------- Increment setting value of Brightness by 1
"DN"--------------------- Decrement setting value of Brightness by 1
Set user controlled value of Brightness (Available only in the normal Power ON
status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.2 CF_CONT Command

Command "CF_CONT_%1" [CR]
"000-063"--------------- Directly specify setting value of Contrast
%1 "UP"--------------------- Increment setting value of Contrast by 1
"DN"--------------------- Decrement setting value of Contrast by 1
Set user controlled value of Contrast (Available only in the normal Power ON
status)
Details The value set by this command will not be stored in the projector. Therefore, when
the power is turned to ALL OFF status, the value returns to the original setting. (It
is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.3 CF_COLOR Command

Command "CF_COLOR_%1" [CR]
"000-063"--------------- Directly specify setting value of Color
%1
"UP"--------------------- Increment setting value of Color by 1
"DN"--------------------- Decrement setting value of Color by 1
Set user controlled value of Color (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.4 CF_TINT Command

Command "CF_TINT_%1" [CR]
"000-063"--------------- Directly specify setting value of Tint
%1 "UP"--------------------- Increment setting value of Tint by 1
"DN"--------------------- Decrement setting value of Tint by 1
Set Tint value (Available only in the normal Power ON status)
The value set by this command will not be saved to the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
18/79