Cf_H-Pos Command; Cf_V-Pos Command; Cf_Ddots Command - Sanyo PLC-XM100/L - 5000 Lumens Manual

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications

8.5.4 CF_H-POS Command

Command "CF_H-POS_%1" [CR]
"0000-nnnn" -------- Directly specify setting value of Horizontal Position
%1
"nnnn" indicates maximum value, which is current value of (Total dots - Display area H)
"UP" ------------------- Increment setting value of Horizontal Position by 1
"DN" ------------------ Decrement setting value of Horizontal Position by 1
Set value of Horizontal Position in PC signal (Available only in the normal Power
ON status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable

8.5.5 CF_V-POS Command

Command "CF_V-POS_%1" [CR]
"0000-nnnn" ------------ Directly specify setting value of Vertical Position
%1
"nnnn" indicates maximum value, which is current (Total Line – Display Area V) value
"UP" --------------------- Increment setting value of Vertical Position by 1
"DN" --------------------- Decrement setting value of Vertical Position by 1
Set Vertical Position value (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable

8.5.6 CF_DDOTS Command

Command "CF_DDOTS_%1" [CR]
"0100-nnnn" -------------- Directly specify setting value of Display Dots
"nnnn" indicates maximum value, which is current value of (Total Dots - Position H).
%1
In this projector, the value should be "even number" and if "odd number" is specified, it
adds 1 to make the value even number.
"UP" ------------------------ Increment setting value of Display Dots by 2
"DN" ------------------------ Decrement setting value of Display Dots by 2
Set setting value of Display Dots in PC signal (Available only in the normal
Power ON status)
Details The value set by this command will not be stored in the projector's memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting.
Acceptable
Response
Unacceptable
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] ---- When input is Video signal
--- When input is no signal
"000" [CR]
"101" [CR] --- When input is Video signal
--- When input is no signal
24/79