Other Status Read Commands; Cr_Status Command; Cr_Signal Command; Cr_Vmute Command - Sanyo PLC-XM100/L - 5000 Lumens Manual

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications

9.12 Other Status Read Commands

9.12.1 CR_STATUS Command

COMMAND "CR_STATUS" [CR]
Get operating status of Projector
Detail
Same as "CR0" in basic command except error code follows it.
Acceptable
Response
%1
Unacceptable

9.12.2 CR_SIGNAL Command

Command "CR_SIGNAL" [CR]
Details Get status whether there is any signal or not.
Acceptable
Response
%1
Unacceptable

9.12.3 CR_VMUTE Command

Command "CR_VMUTE" [CR]
Details Get setting status of Video Mute.
Acceptable
Response
%1
Unacceptable

9.12.4 CR_FREEZE Command

Command "CR_FREEZE" [CR]
Details Get setting status of Freeze.
Acceptable
Response
%1
Unacceptable
"000_%1" [CR]
"00" = Power ON
"80" = Standby
"40" = Countdown in process
"20" = Cooling Down in process
"10" = Power Failure
"28" = Cooling Down in process due to abnormal temperature
"88" =Standby after Cooling Down due to abnormal
temperature
"02" = Invalid RS-232C Command
"24" = Power Save/Cooling Down in process
"04" = Power Save
"21" = Cooling Down in process after turned Off due to lamp
failure
"81"＝ Standby after Cooling Down due to lamp failure
"2C" = Cooling Down in process after Power Off due to
Shutter management
"8C" = Standby after Cooling Down due to Shutter
management
"Error Code" [CR]
"000_%1" [CR]
"ON" -------------------------- There is signal
"OFF" ------------------------- There is no signal
"Error Code" [CR]
"000_%1" [CR]
"ON" -------------------------- Set Video Mute (Shutter CLOSE)
"OFF" ------------------------ Cancel Video Mute (Shutter OPEN)
"Error Code" [CR]
"000_%1" [CR]
"ON" ---------------------------- Freeze is enabled
"OFF" -------------------------- Freeze is disabled
"Error Code" [CR]
77/79