Cr_Ptimer Command; Cr_Ptime Command; Cr_Keydis Command; Cr_Security Command - Sanyo PLC-WM4500/L - 4500 Lumens Manual

PLC-WM4500/WM4500L Expand Serial Command Functional Specifications

9.11.30 CR_PTIMER Command

Command "CR_PTIMER" [CR]
Details Get setting status of P-timer
Acceptable
Response
%1
Unacceptable

9.11.31 CR_PTIME Command

Command "CR_PTIME" [CR]
Details Get setting time for count down mode of P-timer
Acceptable
Response
%1
Unacceptable

9.11.32 CR_KEYDIS Command

Command "CR_KEYDIS" [CR]
Details Get status of RC/KEY (valid or invalid)
Acceptable
Response
%1
Unacceptable

9.11.33 CR_SECURITY Command

Command "CR_ SECURITY" [CR]
Details Get ON/OFF setting status of Security on menu.
Acceptable
Response
%1
Unacceptable

9.11.34 CR_PJLOCKNOW Command

Command "CR_PJLOCKNOW" [CR]
Details Get actual setting status of PIN code lock
Acceptable
Response
%1
Unacceptable
"000_%a" [CR]
"ON" -------------------- P-timer is activated
"STOP" ---------------- P-timer is
"OFF" ------------------ Exit P-timer function
"Error Code" [CR]
"000_%a" [CR]
"001" – "180" ----------------------- 1 to 180 minutes
"Error Code" [CR]
"000_%1" [CR]
"NONE" -------------------------- RC and KEY, both are valid
"RC" ------------------------------- RC is invalid
"KEY" ----------------------------- KEY is invalid
"Error Code" [CR]
"000_%1" [CR]
"ON" ------------ PJ is locked
"OFF" ----------- PJ is not locked.
"Error Code" [CR]
"000_%1" [CR]
"LOCK" ------ PJ is locked
PIN code lock is set to ON1/ON2 on the menu and PJ PIN
code is not entered, therefore PJ is actually locked.
"FREE" ------- PJ is unlocked (either A or B)
A) PJ lock is set to OFF on the menu
B) PJ lock is set to ON1/ON2 on the menu, but PIN code
Lock mode is released because PJ PIN code is entered.
"Error Code" [CR]
73/78
temporarily suspended