Cf_Progv Command; Cf_Image Command - Sanyo PLC-XM100/L - 5000 Lumens Manual

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications

8.4.11 CF_PROGV Command

Command "CF_PROGV_%1" [CR]
"ON" ----------------- Set Progressive scan to On.
"FILM" --------------- Set Progressive scan to Film.
%1 "OFF" ---------------- Set Progressive scan to OFF.
"UP" ------------------ Switch setting forward direction (OFF→ON→FILM→OFF)
"DN" ------------------ Switch setting backward direction (OFF→FILM→ON→OFF)
Set Progressive scan mode. (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.12 CF_IMAGE Command

Command "CF_IMAGE_%1" [CR]
"STAND" ------ Standard(Image adjust value is set to factory default for Still Image)
"REAL------------------ Real (Fixed value to display graphic image with natural tone)
"CINEMA"------------- Cinema (Fixed value to focus on tone reproduction for movie)
"CUSTOM1" ------------- Image1 （the value adjusted and stored by user）
"CUSTOM2" ------------- Image2 （the value adjusted and stored by user）
"CUSTOM3" ------------- Image3 （the value adjusted and stored by user）
"CUSTOM4" ------------- Image4 （the value adjusted and stored by user）
%1
"CUSTOM5" ------------- Image5 （the value adjusted and stored by user）
"CUSTOM6" ------------- Image6 （the value adjusted and stored by user）
"CUSTOM7" ------------- Image7 （the value adjusted and stored by user）
"CUSTOM8" ------------- Image8 （the value adjusted and stored by user）
"CUSTOM9" ------------- Image9 （the value adjusted and stored by user）
"CUSTOM10" ----------- Image10 （the value adjusted and stored by user）
Select Image Mode (Available only in the normal Power ON status)
Parameter "CUSTOM1" to "CUSTOM10" corresponds to "Image1" to "Image10"
Details displayed in projector OSD menu on selecting Image.
The value set by this command is stored in EEPROM so that the setting can
remain effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
21/79