PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications
8.7.14 CF_HSCALE Command
Command
"CF_HSCALE_%1" [CR]
"035" ---------------------- +35
"031" ---------------------- +31
:
"002" ---------------------- +2
"001" ---------------------- +1
"000" ---------------------- ±0
"‐01" ---------------------‐1
%1
"‐02" ---------------------‐2
:
"‐31" ---------------------‐31
"‐32" ---------------------‐32
"UP" --------------------- Increment setting value of Hscale by 1
"DN" --------------------- Decrement setting value of Hscale by 1
Set Hscale (Available only in the normal Power ON status)
*When the screen mode is not in "Custom", projector changes image mode into
Details
Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable
Response
Unacceptable
8.7.15 CF_HPOS Command
Command
"CF_HPOS_%1" [CR]
"015" --------------------- +15
"014" --------------------- +14
:
"002" --------------------- +2
"001" --------------------- +1
"000" --------------------- ±0
"‐01" ---------------------‐1
%1
"‐02" ---------------------‐2
:
"‐14" ---------------------‐14
"‐15" ---------------------‐15
"UP" --------------------- Increment setting value of Hposition by 1
"DN" --------------------- Decrement setting value of Hposition by 1
Set H Position (Available only in the normal Power ON status)
*When the screen mode is not in "Custom", projector changes image mode into
Details
Custom by receiving this command.
*When there is no signal detected, projector returns 101 and the command does
not execute.
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
36/79