Cr_Keydis Command; Cr_Pjlocknow Command; Cr_Pjlockmenu Command; Cr_Fanmode Command - Sanyo PLC-WL2503 - 2500 Lumens Manual

PLC-WL2500 / WL2501/ WL2503 Expand Serial Command Functional Specifications

9.11.24 CR_KEYDIS Command

Command "CR_KEYDIS"(CR)
This command is available to models with top panel buttons only.
Details
Get disability status of RC/Projector keys (valid or invalid)
Acceptable
Response
Unacceptable

9.11.25 CR_PJLOCKNOW Command

Command "CR_PJLOCKNOW" [CR]
Details Get if PJ lock is actually in operation
Acceptable
Response
Unacceptable

9.11.26 CR_PJLOCKMENU Command

Command "CR_PJLOCKMENU" [CR]
Details Get status of PJ Lock on Menu
Acceptable
Response
Unacceptable

9.11.27 CR_FANMODE Command

Command "CR_FANMODE"[CR]
Details Get selected Fan mode
Acceptable
Response
Unacceptable

9.11.28 CR_FANCONTROL Command

Command "CR_FANCONTROL"[CR]
Details Get selected Fan control setting status
Acceptable
Response
Unacceptable
"000_%a"[CR]
"NONE" -------------------------- RC / Projector keys are valid
%a "RC" ------------------------------ RC keys are invalid
"KEY" ----------------------------- Projector keys are invalid
"Error code"[CR]
"000_%1[CR]
"LOCK" ------------- PJ Lock is in operation. PJ Lock status is ON-1
%1 "FREE" ------------- PJ Lock is released. PJ Lock status is OFF, or,
"Error Code" [CR]
"000_%1[CR]
"ON1" ------------- PJ Lock status is On-1
%1 "ON2" ------------- PJ Lock status is On-2
"OFF" ------------- PJ Lock status is OFF
"Error Code" [CR]
"000_%a"[CR]
"L1" ----------------------- Fan mode is L1
%a
"L2" ----------------------- Fan mode is L2
"Error code"[CR]
"000_%a"[CR]
"OFF" ----------------------- Fan control is OFF
%a "ON1" ----------------------- Fan control is ON1
"ON2" ----------------------- Fan control is ON2
"Error code"[CR]
67/72
or ON-2 on Menu, and PJ PIN CODE is not
entered so that projector is actually locked.
status is ON-1 or ON-2 on Menu but PJ PIN
CODE is entered correctly so that PJ Lock is
released.