Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual page 46

These settings can be changed after server registration.
For details on how to modify these settings, refer to
[Use Admin LAN redundancy] checkbox
Check this when performing redundancy for the NIC on the admin LAN.
[Apply Admin LAN NIC settings] checkbox
-
When not changing the Admin LAN NIC settings
NIC1 (Index1) and NIC2 (Index2) are used, without changing the NICs used for the admin LAN, the HBA address rename
setup service, or for redundancy of the admin LAN.
-
When changing the Admin LAN NIC settings
NIC1 (Index1) and NIC2 (Index2) are used as the NICs for the admin LAN, the HBA address rename setup service, and
redundancy of the admin LAN.
Select the NICs to use from Admin LAN (MAC address1) and Admin LAN (MAC address2).
Admin LAN (MAC address 1)
Displayed when the [Apply Admin LAN NIC settings] checkbox is selected.
Select the NIC to use for the admin LAN. The IP address allocated to the selected NIC is displayed in [Admin LAN (IP address)].
When an IP address is not allocated, specify the admin LAN (IP address) of the server to register.
Admin LAN (MAC address 2)
Displayed when the [Apply Admin LAN NIC settings] checkbox is selected.
Select the NICs used for the HBA address rename setup service or for admin LAN redundancy.
For the following cases, select the [Disable MAC address 2].
-
When not using the HBA address rename setup service
-
When not performing admin LAN redundancy
Note
-
For details about the network interfaces used on the admin LAN, refer to "9.1.1 Admin LAN Network Design" in the "Design
Guide CE".
If an incorrect network interface is used, Resource Orchestrator will use a wrong MAC address for the admin LAN.
An admin LAN IP address is required even when registering a spare server.
Enter an IP address that does not conflict with the IP address of any other managed server on the admin LAN.
-
When using backup and restore, cloning, or HBA address rename, the NIC (or LAN expansion board) must support PXE boot.
-
When registering a newly-mounted PRIMERGY BX900 server, as recognition of this server's admin LAN MAC address will
take time, error message number 61142 may be displayed.
In this case, after registration has been canceled, right-click the chassis on the server resource tree and select [Update] from the
popup menu to request an update of hardware properties. This will update the MAC address to the correct value. This may also
take a few minutes to obtain hardware information and update internal properties.
Confirm that the correct MAC address is displayed correctly before registering the server again.
For details on the appropriate corrective action, refer to "Message number 61142" in "Messages".
-
A server running a VM host can still be registered as a physical OS if its [Server OS category] is set to [Windows/Linux]. (For
Windows Server 2008, etc.)
A VM host server that was mistakenly registered as a physical OS should be deleted and re-registered as a VM host.
-
The same NIC cannot be selected for [Admin LAN (MAC address 1)] and [Admin LAN (MAC address 2)].
-
For the following cases, after selecting [Disable MAC address 2] for [Admin LAN (MAC address 2)], the lowest numbered
NIC which is not used for [Admin LAN (MAC address 1)] is used for Admin LAN2.
-
When using the HBA address rename setup service
-
When performing admin LAN redundancy
"7.1.10 Changing Boot Options".
- 30 -