Operation; Releasing Configuration - Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual

3.
Start the Destination L-Server for Usage Change
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.
-
When using multiple L-Servers, switching between them, on unused physical servers in a server pool
Usage can be changed by repeating the following procedure.
1.
Confirm the Server Pool
Confirm whether an unused physical server exists in the server pool.
2.
Start the Destination L-Server for Usage Change
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.

17.9.2 Operation

The methods for operating physical servers after usage changes are as follow.
Perform the procedure given in
-
When using multiple L-Servers, switching between them, on a single physical server
Usage can be changed by repeating the following procedure.
1.
Stop the Source L-Server for Usage Change
Stop L-Servers operating on physical servers which are required for change usage.
For details, refer to
2.
Start the Destination L-Server for Usage Change
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.
-
When using multiple L-Servers, switching between them, on unused physical servers in a server pool
Usage can be changed by repeating the following procedure.
1.
Confirm the Server Pool
Confirm whether an unused physical server exists in the server pool.
2.
Start the Destination L-Server for Usage Change
Start the destination L-Server for usage change.
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.
Point
-
Usage cannot be changed, while the L-Server is stopped temporarily during L-Server restart.
-
When power operation has been performed directly on the physical server using the ROR console or commands, without performing
power operation of the L-Server, the L-Server which was last operated will start.
-
If the last L-Server that was operated has already been started on another physical server, its status will change so there is no boot
disk and it will fail to start.

17.9.3 Releasing Configuration

This section explains how to release configurations of the L-Server for usage change.
"17.1.1 Starting an L-Server".
"17.1.1 Starting an L-Server".
"17.9.1 Configuring L-Servers for Usage
"17.1.2 Stopping an L-Server".
"17.1.1 Starting an L-Server".
"17.1.1 Starting an L-Server".
Change" before performing any operations.
- 231 -