Os] Tab; Creation Of Virtual L-Servers Using Parameters - Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual

16.2.5 [OS] Tab

Enter the parameters to set for the OS when creating the L-Server. This setting is valid only if an image is specified in the [General] tab.
When using an L-Server with the server type [Physical], refer to "B.7 [OS] Tab Configuration" in the "Setup Guide CE".

16.3 Creation of Virtual L-Servers Using Parameters

This section explains how to configure a virtual L-Server with server, storage, and network specifications configured, without using an
L-Server template.
Specify the values on the following tabs:
-
[General] Tab
-
[Server] Tab
-
[Disk] Tab
-
[Network] Tab
-
[OS] Tab
Use the following procedure to create L-Servers:
1.
Right-click the target resource folder in the orchestration tree, and select [Create]-[L-Server] from the popup menu.
The [Create an L-Server] dialog is displayed.
2.
Set the items required in each tab, and click <OK> to create the L-Server.
Note
-
Each item to set has an upper limit.
Even when valid values are specified, the creation of an L-Server may fail depending on the availability of resources in resource pools,
the hardware configuration, and the VM management software specifications.
-
When creating a virtual L-Server, if there are any values configured in the VM specific information definition file, those values are
used.
For details on VM specific information definition files, refer to "C.1 Definition Files Commonly Shared when Creating Virtual L-
Servers" and "Chapter 8 Creating Definition Files" in the "Setup Guide CE".
[Xen]
-
When using RHEL5-Xen, L-Server creation cannot be performed using the ROR console. Use the rcxadm lserver command.
For details on the rcxadm lserver command, refer to "3.6 rcxadm lserver" in the "Reference Guide (Command/XML) CE".
[Hyper-V]
-
When using dynamic memory and memory weight, Windows Server 2008 R2 Service Pack 1(SP1) or later must be applied to the VM
host, and SCVMM must be upgraded to System Center Virtual Machine Manager 2008 R2 Service Pack 1(SP1) or later. If there are
no VM hosts or SCVMM with SP1 applied, creation of an L-Server for which dynamic memory is enabled, or memory weight is
specified will fail.
[Solaris Zones]
-
Calculate the cap value to configure for the non-global zone from the number of CPUs and the CPU performance.
For details, refer to "C.7.6 Creating an L-Server" in the "Setup Guide CE".
-
When a VM host not managed with server management software is used, virtual L-Servers cannot be created.
In this case, link L-Servers with configured virtual machines.
For details, refer to "Chapter 18 Linking L-Servers with Configured Physical Servers or Virtual
[OVM for SPARC]
- 180 -
Machines".