When Resources Are Already Allocated (Allocated) - Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual

-
Check the [Automatic (when powered off)] checkbox of [Resource release] on the [Server] tab.
Operation
The operation method is shown below.
-
When using multiple L-Servers, switching between them, on a single physical server
Usage can be changed by repeating the following procedure.
1.
Check the Physical Server and L-Server of the Source L-Server for Usage Change
2.
Stop the Source L-Server for Usage Change
Stop L-Servers operating on physical servers which are required for change usage.
For details, refer to
3.
Start the Destination L-Server for Usage Change
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.
-
When using multiple L-Servers, switching between them, on unused physical servers in a server pool
Usage can be changed by repeating the following procedure.
1.
Confirm the Server Pool
Confirm whether an unused physical server exists in the server pool.
2.
Start the Destination L-Server for Usage Change
For details, refer to
After changing the configuration, the L-Server before changing cannot be operated, until the new L-Server has finished starting.

17.9.1.2 When Resources are Already Allocated (allocated)

This section explains configuration and operation when resources have been allocated to the L-Server.
Settings
Perform step 1 the same number of times as the number of physical servers which are used for usage change.
1.
Create and Register Each Resource
Perform resource creation and registration, referring to
in Resource Pools".
2.
Create an L-Server (First server)
Create an L-Server for which resources are already allocated (allocated), referring to
Perform the following configuration:
-
Set [Deploy] for image deployment from the select a cloning image section of the [General] tab.
-
Do not check the [None (Definition only)] checkbox from the [General] tab.
-
Check the [Automatic (when powered off)] checkbox of [Resource release] on the [Server] tab.
3.
Change L-Server Configuration
When using multiple L-Servers, switching between them, on a single physical server
Repeat the following procedure the same number of times as the number of physical servers which are used for usage change.
"17.1.2 Stopping an L-Server".
"17.1.1 Starting an L-Server".
"17.1.1 Starting an L-Server".
"Chapter 5 Registering Resources" and
- 229 -
"Chapter 14 Registering Resources
"Chapter 16 Creating L-Servers".