Fujitsu ServerView Resource Orchestrator Cloud Edition V3.1.0 User Manual page 254

-
Virtual machines are managed using VMware and vCenter Server
-
Datastores are used, and the datastores are displayed in the storage tree as virtual storage
-
SAN storage or NAS storage supported by VMware, excluding built-in disks on the server and iSCSI storage, is used
-
The following device paths are used for data disks
-
SCSI:0:1 - SCSI:0:6
-
SCSI:0:8 - SCSI:0:14
-
SCSI:1:0 - SCSI:1:6
-
SCSI:1:8 - SCSI:1:14 AM
-
SCSI:2:0 - SCSI:2:6
-
SCSI:2:8 - SCSI:2:14 AM
-
SCSI:3:0 - SCSI:3:6
-
SCSI:3:8 - SCSI:3:14 AM
Note
When using Raw Device Mapping, or when using a device path other than those listed above, only servers can be managed.
For disks using any other device path, assign 56 or higher as the disk number.
When collecting a cloning image for deploying an L-Server, use SCSI:0:0 for the system disk.
[Hyper-V]
-
Virtual machines are managed using SCVMM
-
MSFC has been added to VM hosts
-
Cluster disks are configured as shared cluster volumes, and the shared volumes are displayed in the storage tree as virtual storage
-
A SAN volume has been configured as a cluster disk
-
SAN storage supported by Hyper-V, excluding built-in disks on the server and iSCSI storage, is used
-
The following device paths are used for data disks
-
SCSI:0:1 - SCSI:0:14
-
SCSI:1:0 - SCSI:1:14 AM
-
SCSI:2:0 - SCSI:2:14 AM
-
SCSI:3:0 - SCSI:3:14 AM
Note
When using pass-through devices or difference disks, or when using a device path other than those listed above, only servers can be
managed.
For disks using any other device path, assign 60 or higher as the disk number.
When collecting a cloning image for deploying an L-Server, use IDE:0:0 for the system disk.
Note
Disks which are created in virtual storage which is not registered in the storage pool can also be operated. When managing the amount of
resources in the virtual storage, register the virtual storage in the storage pool.
- 238 -