How to Use This Guide
How to Use This Guide
Read through this guide completely to familiarize yourself with its contents and gain an
understanding of the features and capabilities of the stackable Ethernet switches. A
general knowledge of data communications networks is helpful when setting up the
switches.
This preface provides an overview of this guide and the SecureStack A2 manual set, a
brief summary of each chapter and defines the conventions used throughout this guide.
To locate information concerning various subjects in this guide, refer to the following
table:
For...
An overview of the SecureStack A2 features and
how to obtain technical support
Network requirements that must be met before
installing the SecureStack A2
Instructions to install the SecureStack A2 on a flat
surface or in a standard 19-inch rack and
configure the SecureStack A2 in a stacked
configuration
Troubleshooting installation problems and
diagnosing network/operational problems using
the LANVIEW LEDs
Specifications, environmental requirements, and
physical properties of the SecureStack A2 and
optional Mini-GBICs
Related Documents
The following documents can help you to set up and manage the switch:
•
SecureStack A2 Configuration Guide describes how to use the Command Line Interface
(CLI) to set up and manage the A2 switches.
•
Cabling Guide provides information concerning network cabling, dB loss, and other
cabling specifications and usage.
The manuals listed above can be obtained from the World Wide Web in Adobe Acrobat
Portable Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
Unlike the SecureStack A2 Configuration Guide, the Cabling Guide is not listed
alphabetically on the web site. Instead, it is under the Overview Guides link.
xvi About This Guide
Refer to...
Chapter 1,
Introduction
Chapter 2,
Network Requirements
Chapter 3,
Hardware Installation
Chapter 4,
Troubleshooting
Appendix A,
Specifications
Need help?
Do you have a question about the Enterasys SecureStack A2 A2H124-24P and is the answer not in the manual?
Questions and answers