Chassis Bottom, Rubber Feet Placement - Enterasys SecureStack A2 A2H124-24P Hardware Installation Manual

Installing the Switch on a Flat Surface
Figure 3-1
1 Bottom of chassis as seen when chassis is
resting on its back
2 Locations to install the rubber feet (four locations)
3-4 Hardware Installation

Chassis Bottom, Rubber Feet Placement

Á
Â
Â
Note: If a number of switches are being installed in a stack, repeat steps 1 through 4 to
install the rubber feet on each switch before continuing with the installation.
À
Â
Â
3 Rubber feet with adhesive backing
(four)