About This Guide; Important Notice; Who Should Use This Guide - Enterasys SecureStack C3G124-24P Installation Manual

This guide provides an overview, installation and troubleshooting instructions, and
specifications for the Enterasys
Gigabit Ethernet switches.
For information about the Command Line Interface (CLI) set of commands used to
configure and manage the C3G124‐24P or C3G124‐48P, refer to the Enterasys Networks
SecureStack C3 Configuration Guide.
This preface provides an overview of this guide and the SecureStack C3 manual set, and
explains the symbols used throughout this guide.
Depending on the firmware version used in the switch, some features described in this document
may not be supported. Refer to the Release Notes shipped with the switch to determine which
features are supported.

Who Should Use This Guide

This guide is intended for a network administrator responsible for installing and setting
up the stackable switches.
Note: In this guide, the following terms are used:
• Switch refers to both C3G124-24P
• MGBIC (Mini-Gigabit Interface Card) refers to optional small form pluggable (SFP)
interface modules that plug into the fixed front panel MGBIC slots.
• PoE refers to Power over Ethernet (IEEE 802.3af).
Electrical Hazard: Only qualified personnel should perform installation procedures.
Riesgo Electrico: Solamente personal calificado debe realizar procedimientos de
instalacion.
Elektrischer Gefahrenhinweis: Installationen sollten nur durch ausgebildetes und
qualifiziertes Personal vorgenommen werden.

About This Guide

®
SecureStack C3G124‐24P and C3G124‐48P stackable PoE
and C3G124-48P, unless otherwise noted.

Important Notice

SecureStack C3 Installation Guide xiii
®