7.4.1
Configuring STA Bridge
The STA Bridge Configuration screen
following table describes the STA Bridge configuration parameters.
Figure 7-5 STA Bridge Configuration Screen
Parameter
Spanning Tree
Protocol
Priority
(Figure
Default
ENABLED
32768
7-5) to set the STA Bridge parameters. The
Description
Enables this parameter to participate in an STA
compliant network.
Device priority is used in selecting the root device,
root port, and designated port. The device with the
highest priority becomes the STA root device.
However, if all devices have the same priority, the
device with the lowest MAC address will then become
the root device.
Enter a value from 0 - 65535.
Remember that the lower the numeric value, the higher
the priority.
Device Control Menu Screens
Using the Spanning Tree Algorithm
7-9