Setting Password Protection - Enterasys 5G1XX Local Management User’s Manual

Setting Password Protection

•
Configuring IGMP multicast filtering
•
Configuring port operation (enable/disable, port speed, full/half duplex and flow control)
(Section 10.14)
•
Configuring the Unicast Address table
•
Setting a default gateway
•
Configuring SmartTrunks
10.2 SETTING PASSWORD PROTECTION
The switch is factory-configured with administrator access rights to the console menus set to
READ/WRITE. This setting allows anyone to use the console menus to modify any operational
parameter. To protect the configuration of the switch from unauthorized modification, you should
enable password protection to the console menus.
To enter a password, proceed as follows:
1. Select Management Setup Menu from the Main Menu and press [ENTER].
2. Select Console Login Configuration and press [ENTER].
3. For the "ADMIN" user type, enter a password containing up to 11 alphanumeric characters.
Note that the password is not case sensitive.
By factory default, there is no password configured. This means that at the login: prompt, all you
have to do is type "admin" for the username and press [Enter] to gain READ/ WRITE access to the
console menus. When you configure the password parameter, the factory default setting is
deactivated and the new password governs access to the console menus.
If you forget your password, contact your Enterasys Networks Support Representative.
NOTE: You are automatically logged out from the console menus based on the
Lock-out Time setting in the Console Login Configuration Menu. A setting of "0" permits
the console menus to remain available indefinitely.
10-2 Configuring and Monitoring the Switch
(Section
(Section
(Section 10.16)
(Section 10.17)
10.13)
10.15)