Management Terminal Setup
To connect the switch module to a PC or compatible device running the VT terminal emulation,
proceed as follows:
1. Connect the RJ45 connector at one end of the cable (supplied in the kit) to the COM port on the
switch module.
2. Plug the RJ45 connector at the other end of the cable into the RJ45-to-DB9 adapter (supplied in
the kit).
3. Connect the RJ45-to-DB9 adapter to the PC communications port.
NOTE: If using a modem between the VT compatible device and the COM port of the
switch module, use the appropriate connector included in the console cable kit. Refer to
the modem manufacturer's information for proper operation and setup of the modem.
The 5H102-48 module is shown in
Figure 2-1 Management Terminal Connection
2.1.2
Management Terminal Setup Parameters
Table 2-1
lists the setup parameters for the local management terminal.
2-2
Local Management Requirements
Figure 2-1
as an example.
E5