Table of Contents
Advertisement
Spanning Tree Protocol Parameters
Table A-1 Spanning Tree Protocol Defaults (Continued)
Parameter
Cost
Component of
Each Port
For detailed information on the operation of the Spanning Tree Protocol, refer Section 4 of IEEE
Standard 802.1D, ISO/IEC 10038:1993.
A.3.1
Spanning Tree Protocol Operation
When the Spanning Tree Protocol is enabled for the first time or when there is a change in the
network topology, such as a failure or the addition or removal of a component, the Spanning Tree
Protocol automatically sets up the active topology of the current network.
A.3.2
Communicating Between Bridges
Periodically, all devices running the Spanning Tree Protocol on a network transmit packets to each
other "in care of" the Bridge Group Address, which all bridges share. When a bridge receives a
frame sent to the Bridge Group Address, the bridge's Spanning Tree Protocol processes the packet.
Application software and other LAN segments ignore the packet. Bridges communicate between
each other in order to determine the Root Bridge.
A.3.3
Selecting a Root Bridge and Designated Bridges
During communication between bridges, one bridge is determined to have the lowest bridge
identifier. This bridge becomes the Root Bridge.
After the Root Bridge has been selected, each LAN segment looks for the bridge that has the
lowest cost relative to the Root Bridge. These bridges become Designated Bridges.
A.3.4
Selecting Designated Ports
Each Designated Bridge selects a Designated Port. This port is responsible for forwarding packets
to the Root Bridge.
A-4
Spanning Tree Concepts
Description
The Spanning Tree Protocol calculates and ensures that an
active topology generates minimal cost paths. A value of
100 is generally used for 10 Mbps Ethernet networks, a
value of 19 for 100 Mbps Fast Ethernet, and a value of 4
for 1000 Mbps Gigabit Ethernet.
Default Value
19
Advertisement
Table of Contents
