Configuring The Wan - Enterasys Security Router X-PeditionTM User Manual

Configuring the WAN

• Clocking speed - For Sync interfaces, an external clock must be provided. Acceptable clock
values range from 2400 Hz to 10 MHz. For Async interfaces, the clock is internally generated
and can be set to the following values using
–
–
–
–
–
–
–
–
–
–
• Statistics - all MIB-II interface statistics are supported.
• Clear commands such as
interface troubleshooting.
• Async mode commands such as
serial line.
• Maximum Receive Unit (MRU) is 1518 bytes (including CRC).
Configuring the WAN
Enter the following commands to configure either a synchronous T1 or asynchronous Serial
interface. For more detailed information on the commands used here, refer to the XSR CLI
Reference Guide and other chapters in this manual.
The following example configures the synchronous T1 controller on NIM 1, port 0 named Acme T1
with the default values of ESF framing and B8ZS line encoding. It also specifies channel group 1
with mapped timeslots 1-5, 8 and 9, assigns the local IP address 192.168.1.1 to the channel group
and sets PPP encapsulation.
XSR(config)#controller t1 1/0
XSR(config-controller<T1/0>)#description T1 "Acme T1"
XSR(config-controller<T1/0>)#framing esf
XSR(config-controller<T11/0>)#linecode b8zs
XSR(config-controller<T11/0>)#channel-group 1 timeslots 1-5,8,9
XSR(config-controller<T11/0>)#no shutdown
XSR(config)#interface serial 1/0:1
XSR(config-if<S1/0:1>)#ip address 192.168.1.1 255.255.255.0
XSR(config-if<S1/0:1>)#encapsulation ppp
XSR(config-if<S1/0:1>)#no shutdown
3-4 Managing LAN/WAN Interfaces
2400 Kbps
4800 Kbps
7200 Kbps
9600 Kbps (default)
14400 Kbps
19200 Kbps
28800 Kbps
38400 Kbps
57600 Kbps
115200 Kbps
clear counters serial
clock rate
and
databits , stopbits , and
:
clear interface serial
parity provide configuration of the
facilitate