Enterasys Security Router X-PeditionTM User Manual page 68

Utilizing the Command Line Interface
Local Bootrom Upgrade
Due to the change in the format of the Bootrom file between version 1.x and version 2.01, a
transitional step is required when updating across these versions only. This transitional step can
be avoided by using the Bootrom Update utility described above.
When you are running a 1.x version of the Bootrom and you try to upgrade to version 2.01 of the
Bootrom file, it will be rejected due to the change in format.
non-redundant Bootrom file that the existing 1_x version bU command can recognize. By
updating and rebooting with this transitional version, you can subsequently use the new
command (which recognizes the new 2.01 format) to update the Bootrom to version 2.01. Be aware
that if you boot with
"Danger!
After upgrading to version 2.01 with
Bootrom updates (which do not involve a change in the bootFirst module) are power-safe.
In summary, when upgrading 1.x to 2.x Bootrom versions only, you must run the
twice - first with the
upgrades you must reboot using
To upgrade your firmware using the Local Bootrom Upgrade, perform the following steps:
1. Power on the XSR by flipping the rear switch and observe the front LEDs. When the system,
VPN, console, NIM1 and NIM2 LEDs turn off, immediately enter <Ctrl-C> on the terminal. If
you miss this time window, power off and try again. The Bootrom monitor menu should
appear as follows:
Copyright 2003 Enterasys Networks Inc.
HW Version: 9002854-02 REV0A Serial Number: 2854019876543210
CPU: IBM PowerPC 405GP Rev. D
VxWorks version: 5.4
Bootrom version: 1.20
Creation date: Aug 26 2002, 11:16:44
Cold Start: SystemReset from powerup
Password:
Entering ROM monitor Type "h" for help
Using default Bootrom password The system is not secure!!!
Use "bp" to change password
XSR1800:
Type h or ? to display the command groups.
2.
Type f to list the file command group.
3.
Type n to list the network command group.
4.
Using the np command, assign the following:
5.
–
–
2-32 Managing the XSR
bootrom_uncmp.fls
Cannot find a good copy of Bootrom"
bootrom_uncmp.fls
X-Pedition Security Router Bootrom
Local IP address (of the XSR).
Remote (host computer) IP address (The host must be on the same subnet as the XSR).
, you will see the following output on the screen:
bootrom2_01.fls
file, then with the upgraded Bootrom. Between
bw .
bootrom_uncmp.fls
, you can reboot and all subsequent
is a transitional,
bU
bU command