Additional Vga Source Controls - Smart Technologies SMART Board 800ixe-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
Command
set red [value]
set green [value]
set blue [value]
set cyan [value]
set magenta [value]
set yellow [value]
set videofreeze [target]
set cc [target]
N O T E
Typically, cc1 displays English (U.S.) subtitles, while cc2 displays other regional languages, such
as French or Spanish, depending on television channel or media setup.

Additional VGA source controls

Your VGA source supports all the general source controls described in General source controls on
the previous page, as well as the commands listed in this section. These settings are unavailable
when the projector is in Standby mode or when the VGA sources are disconnected.
N O T E
Some of these commands are invalid with HDMI input and Composite video sources, and will
return the response "invalidcmd=[command]".
These commands inform you of the current VGA source settings.
Command
get frequency
get tracking
get saturation
get tint
get sharpness
84
Command target range
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=0 to =100
=on
=off
=cc1
=cc2
=off
Response
frequency=[current frequency offset setting]
tracking=[current tracking offset setting]
saturation=[current saturation setting]
tint=[current tint setting]
sharpness=[current sharpness setting]
Response
red=[value]
green=[value]
blue=[value]
cyan=[value]
magenta=[value]
yellow=[value]
videofreeze=[target]
cc=[target]