General Source Controls - Smart Technologies SMART Board 800ixe-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
Field
HDMI
None

General source controls

The following source controls apply to all input sources. HDMI connector source controls are
described in this section. These controls are unavailable when the projector is in Standby mode. You
can specify custom color values for all inputs.
These commands inform you of the current source settings.
Command
get displaymode
get brightness
get contrast
get whitepeaking
get degamma
get red
get green
get blue
get cyan
get magenta
get yellow
get videofreeze
get cc
These commands control the appearance of your source. These settings are unavailable when the
projector is in Standby mode or when the source is disconnected. See Value-based command
methods on page 80 for setting absolute and adjustment commands.
Command
set displaymode [target]
set brightness [value]
set contrast [value]
set whitepeaking [value]
set degamma [value]
83
Description
Switches source to the HDMI input port.
A non-selectable value that appears when you enter a "get input"
command while the projector is in Standby mode.
Response
displaymode=[current display mode setting]
brightness=[current brightness setting]
contrast=[current contrast setting]
whitepeaking=[current whitepeaking setting]
degamma=[current degamma setting]
red=[current red color setting]
green=[current green color setting]
blue=[current blue color setting]
cyan=[current cyan color setting]
magenta=[current magenta color setting]
yellow=[current yellow color setting]
videofreeze=[current video freeze setting]
cc=[current closed captioning language setting]
Command target range
=SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
=0 to =100
=0 to =100
=0 to =10
=0 to =3
Response
displaymode=[target]
brightness=[value]
contrast=[value]
whitepeaking=[value]
degamma=[value]