Network Controls - Smart Technologies SMART Board 800ixe-SMP Configuration And User's Manual

A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
These commands inform you of the current audio output settings.
Command
get volume
get mute
get volumecontrol
These commands control your projector's audio amplifier settings. See Value-based command
methods on page 80 for setting absolute and adjustment commands.
Command
set volume [value]
set mute [target]
set volumecontrol [target]

Network controls

These commands control your projector's network status and settings. These settings are located in
the OSD, and are available even when the projector is in Standby mode. You must locally set the
network and VGA out commands to on for the network abilities to work.
These commands inform you of the current network settings.
Command
get netstatus
get dhcp
get ipaddr
get subnetmask
get gateway
get primarydns
get macaddr
These commands control your network settings.
Command
set dhcp [target]
set ipaddr [target]
set subnetmask [target]
set gateway [target]
set primarydns [target]
86
Response
volume=[current volume setting]
mute=[current mute setting]
volumecontrol=[current volume control setting]
Command target range
=-20 to =20
=on
=off
=on
=off
Response
netstatus=connected
netstatus=disconnected
netstatus=disabled
dhcp=[current DHCP status]
ipaddr=[current IP address]
subnetmask=[current subnet mask number]
gateway=[current network gateway]
primarydns=[current primary domain server]
macaddr=[current MAC address]
Command target range
=on
=off
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
=0.0.0.0 to =255.255.255.255
Response
volume=[value]
mute=[target]
volumecontrol=[target]
Response
dhcp=[current]
ipaddr=[current]
subnetmask=[current]
gateway=[current]
primarydns=[current]