Comtech EF Data SLM-5650 Installation And Operation Manual page 150

SLM-5650 Satellite Modem
Remote Control
Command Arguments
Parameter (Instruction for Command
Type Code and or Response
Qualifier)
Number of N/A 3 bytes
Unread stored
Events
Initialize IEP= None
Events Pointer
Retrieve next N/A 110 bytes
5 unread
Stored Events
Clear All CAE= None
Stored Events
Description of Arguments
to Query
Query only.
Unit returns the Number of stored Events, which remain Unread, in
the form xxx.
Note: This means unread over the remote control.
Example: NUE=126
Command only.
Resets internal pointer to allow RNE? queries to start at the
beginning of the stored events log.
Query only.
Unit returns the oldest 5 Stored Events, which have not yet been
read over the remote control. Reply format: {CR}Sub-
body{CR}Sub-body{CR}Sub-body{CR}Sub-body{CR}Sub-body,
where Sub-body= Axxxxxxxxddmmyyhhmmss,
A being the fault type where:
1=Unit
2=Rx Traffic
3=Tx Traffic
4=Info
xxxxxxxx is the Fault Code number, as in LUF?, TXF?, RXF?, or
Info Code, which is:
00000000=Power Off
00000001=Power On
00000002=Log Cleared
00000004=Global Config Change
If there are less than 5 events to be retrieved, the remaining
positions are padded with zeros.
If there are no new events, the response is RNE*.
Command only.
Forces the software to clear the software events log.
Example: CAE=
Note: This command takes no arguments
Response to
Command
N/A
IEP=
IEP#
N/A
CAE=
CAE?
CAE*
CAE#
B–28
Revision 1
MN/SLM5650.IOM
Query
(Instruction
Response to Query
Code and
Qualifier)
NUE? NUE=xxx
(see description of
arguments)
N/A N/A
RNE? RNE={CR}Axxxxxxxxd
dmmyyhhmmss{CR}Ax
xxxxxxxddmmyyhhmms
s{CR}Axxxxxxxxddmm
yyhhmmss{CR}Axxxxx
xxxddmmyyhhmmss
{CR}Axxxxxxxxddmmy
yhhmmss
(see description for
details of arguments)
N/A N/A