Display Devices; Switching/Enabling Displays (Keyboard) - EUROCOM M375C MILANO User Manual

Display Devices

Besides the built-in LCD, you can also use an external VGA monitor or TV
as your display device. A VGA monitor connects to the external monitor
(VGA) port , a TV to the S-Video Out port
1

Switching/Enabling Displays (Keyboard)

You can switch display devices with the Fn + Display (F6) toggle. With the
video driver installed, you also can use its built-in controls to switch the dis-
play options. If you haven't installed the video driver, refer to (see
Install" on page 4 - 2) for setup instructions. To switch the display options:
1. Plug the VGA monitor or TV into the appropriate port.
2. Press and hold the Fn key, while simultaneously pressing the F6 key.
Note: If you are using a TV use the hot key combinations Ctrl + Alt + F1 (VGA
monitor only), Ctrl + Alt + F2 (TV only) and Ctrl + Alt + F3 (notebook LCD
only), not Fn + F6.
3. You may toggle through the options to display the notebook's LCD only, the
external display alone and the LCD and the external display together (make
sure you allow time for the screens to refresh as you toggle through).
(Figure 3 -
2
1 2
Advanced Controls
Figure 3 - 5
Left Side View
5).
Using the Driver to
Switch Displays
If you only use the key-
board toggle to switch
through the display op-
tions you will not have
all the configuration
options available to
"What to
you. If you want to ac-
cess the options listed
in "Display Devices"
on page 3 - 9
driver control panel to
configure the settings
as per
abling Displays (Driv-
er)" on page 3 -
Display Devices 3 - 9
3
use the
"Switching/En-
10.