Power - EUROCOM M375C MILANO User Manual

Power

Problem
You turned on the power
but it doesn't work.
The Battery LED power
indicator , is blinking
orange.
The system has power
but no picture appears.
You are losing battery
power too quickly.
The computer feels too
hot.
The battery pack will not
charge.
Battery missing / incorrectly installed. Check the battery bay, make sure the battery is
present and seated properly (the design of the battery only allows it to go in one way).
Make sure there's nothing interfering with the battery contacts.
Low Battery. Plug in the AC power source. If the computer doesn't start up immediately,
turn it off then on again.
The sleep/resume key combination, Fn + Esc, or other configured key combination, has
been toggled. Press Fn + Esc, or other configured key combination. Wait a few moments
before trying this control again.
The system is using too much power. If your OS has a Power Options scheme (see
"Power Schemes" on page 3 -
device that is drawing a lot of power.
Make sure the computer is properly ventilated and the fan port is not blocked. If this
doesn't cool it down, put the system into Hibernate mode or turn it off for an hour. Make
sure the vents aren't blocked and the computer isn't sitting on a thermal surface (see
"Overheating" on page 1 -
The battery pack is exposed to an excessively hot or cold environment. Place the battery
in a suitable environment and after it returns to normal temperature try again. The battery
may be bad and may need to be replaced, contact your service center for more details.
Possible Cause - Solution
19) check its settings. You may also be using a PC Card
16). Make sure you're using the correct adapter.
Troubleshooting
Power 8 - 7
8