Setting The Bnc Terminal Entry Mode - Epson PowerLite 5350 Installation Manual

•

Setting the BNC terminal entry mode

To use the BNC terminal, set the input video signal mode as described below.
(1) Press [Menu] button to display the Main menu. Press [Sync +, -](control panel) or
[Enter](remote control) button on the Main menu to select Setting.
(2) Press[ (Enter) (control panel) or [Enter] (remote control).Press [Sync +, -](control
panel) or [Enter](remote control) button to select "BNC".
(3) Press [Tracking +, -] (control panel) or[Enter] (remote control) button to select
RGB.
(4) Press Menu button to close the menu.
(5) Place the BNC switch of the I/O terminal at the back of the projector to the "BNC"
side.
(6) For EMP-7350/EMP-7250/EMP-5350, place the BNC switch of the I/O terminal at
the back of the projector to the "BNC" side.
RGB : When the computer signal is used.
YcrCb : When the video signal is used.
31