3-3.Operating/controlling the stack-connected projectors
To establish or release the stack-connection, use the "application software ELP-Link IV" which is
installed in a computer.
For further information about the installation of ELP-Link IV, refer to the Owner's manual supplied
with the projector.
3-3-1.Establishing the stack-connection
(1) Connect the master projector to a computer.
Caution:
Extending the main cable for connection may cause malfunction. If extending a cabling, a serial
cable must be extended.
• For IBM PC/AT compatible machine (DOS/V PC), NEC PC-98 or compatible machine users
* For NEC PC-98 or compatible machine users, an adapter supplied with a computer or a
commercially available adapter is required to connect to it.
To serial port
PC serial cable
•
For Macintosh users:
To printer or
modem port
MAC serial cable
(2) Plug all stack-connected projectors in the wall outlet, place them in the standby
mode. (The orange power indicator comes on.)
To Mouse/Com1 or 2
Main cable
To Mouse/Com1 or 2
Main cable
52
Master projector[
Master projector[