3-2.Connection For Stack Projection Of The Computer Image; 3-2-1.If The Computer Has A 15-Pin Micro-D-Style (Bnc) Output Port - Epson PowerLite 5350 Installation Manual

3-2.Connection for stack projection of the computer image

In case of the stack-connection, the first projector is connected as a master , and the next
projector is connected as a slave projector 1. Up to 4 projectors including the master projector can
be connected on the stack-connection.

3-2-1.If the computer has a 15-pin micro-D-style (BNC) output port

Prepare the necessary number of 15-pin micro-D-style cables for connecting the projectors to be
used.
(1)Connect the one end of the 15-pin micro-D-style (BNC) connector to the monitor
port of a computer.
Note:
• Except for a computer with the "15-pin micro-D-style" port, an adapter supplied with a computer
or a commercially available adapter can be used to connect to the computer.
• To connect a Macintosh desktop computer or PowerBook, the MAC disk top adapter and MAC
monitor adapter supplied with the projector may be required to connect to it.
• The following illustration shows the cabling using the "15-pin micro-D-style" cable.
computer has a BNC monitor port, install a cabling as referring to the instruction manual supplied
with the computer.
• The cable from the computer can be connected to the BNC on the master projector. In this case,
make the necessary settings as referring to the section "Setting the BNC terminal entry mode"
described below.
Caution:
• If a universal extension cable is used to connect to a computer, always use a coaxial cable with a
coaxial wire for the H Sync and V Sync of the Video signal to avoid an unnecessarily long
cabling. The long cabling may cause image noise.
• Never tie the computer cable and power cable together. It may cause malfunction.
(2)Connect the other one end of the 15-pin micro-D-style connector to the
"Computer1" of the master projector.
Monitor port or
video port
Master projector
15-pin micro-D-style
47
If the
Computer1
terminal