Removing The P_Front Sensor; Removing The Lever Position Sensor / Hd_Slid Hp Sensor - Epson Stylus Pro 9000 Service Manual

EPSON Stylus Pro 9000

REMOVING THE P_FRONT SENSOR

1. Remove the lower paper guide (refer to "Lower Paper Guide Removal" on
page 78).
2. Disconnect the cable from the connector CN11 on the relay board.
3. Remove the one screws (CP(W) M3x6) securing the sensor assembly, and
remove the P_FRONT sensor together with the mount plate.
Figure 4-37. P_FRONT sensor removal
Disassembly & Assembly
One screw
(behind the sensor board)
REMOVING THE LEVER POSITION SENSOR / HD_SLID HP
SENSOR
1. Remove the side cover R (refer to "L/R Side Covers Removal" on page
75).
2. Disconnect the cable from the connectors on the relay board.
CN17 = to HD_SLID HP sensor
CN10 = to LEVER POSITION sensor
3. Remove the two screws (CP(W) M3x6) securing each sensor assembly,
and remove the LEVER POSITION / HD_SLID HP sensor together with the
mount plate.
Figure 4-38. LEVER POSITION / HD_SLID HP sensor removal
Disassembly Flow
HD_SLID HP sensor
LEVER POSITION sensor
Revision B
95