Epson Stylus Pro 9000 Service Manual page 156

EPSON Stylus Pro 9000
5. Employing four people, lift the printer body as shown in the figure below.
Lifting the printer requires four people, and all four
people need to lift the printer by the hand position
while supporting/steadying the printer with their free
hands.
Hand positions
Maintenance & Setup
Hand positions
Unpacking and Installing
6. To set the printer on the stand, tilt the printer forward and slide the front-
bottom section of the printer under the hooks on both sides of the top of the
stand. Then carefully lower the rear of the printer so the pegs fit correctly
into the holes in the printer.
After setting the printer body on the stand correctly, at
least one person needs to support the printer body to
make sure it does not fall to the rear.
(Once the bolts in step 6 are secured, you no longer
need to support the body.)
Revision B
156