Epson Stylus Pro 9000 Service Manual page 87

EPSON Stylus Pro 9000
9. Using round-nosed pliers, remove the "Tension Spring, 9.9".
Tension Spring, 9.9
Figure 4-22. Printhead Tension Spring and Screw Removal
10. Remove the CB M3x6 screw, also called the "H Spacer" screw, and then
remove the printhead from the carriage.
11. Remove the flat cable from the back of the printhead).
Disassembly & Assembly
12. Repeat steps 10 and 11 for the other printhead if necessary.
CB M3x6/H
Disassembly Flow
n
When replacing the printheads, fold the flat cable behind
the printhead and make sure the printhead snaps fully into
place. When properly installed, the printhead ID will be
directly behind and at the same height as the PG Cam
Shaft. If the PG Cam Shaft does not partially block the line
of sight of the printhead ID (when looking at the ID level/
from straight in front), the printhead is not installed
properly.
n
When attaching the dampers to the printhead, follow the
same order, left to right, as shown on the control panel:
K, C, M, LC, LM, Y.
Revision B
87