Adj X Head Slant (B/C Heads) - Epson Stylus Pro 9000 Service Manual

EPSON Stylus Pro 9000

ADJ X HEAD SLANT (B/C HEADS)

This function prints a check pattern (one-at-a-time for each head) to make sure
the printheads are installed straight up-and-down. If the pattern confirms one or
both heads are offset, at a slant, use the corresponding "Head Adjust Lever A"
to straighten the slanted head.
1. Make sure "Adj: x Head Slant" appears in the LCD, and press the Enter
button. (x = B or C depending on the printhead)
2. After the check pattern prints, "x Slant Check End" (x = B or C head)
appears in the LCD. Compare the printed pattern with the illustration
below. Press Enter if the adjust level is OK like the top row shown below. If
there is a slant, open the front cover, release the carriage lock by hand,
and move the carriage away from the carriage cap position. Next, loosen
the screw securing the head that is printing at a slant, and move the Head
Adjust Lever A left or right depending on the slant direction. Tighten the
screw. (The C head pattern prints with different colors.)
Magenta
B head check
pattern
Light
Magenta
C head check
pattern
3. After finishing the slant-adjustment procedure for both heads, move the
carriage back to the capping position by hand and close the front cover.
Adjustment
Black
Light
Cyan
4. Make sure "x Slant Check End" appears, and press the Enter button if the
check pattern prints with no slant. Press the SelecType or Item button if the
pattern contains slants and you have adjusted the heads. (You may need
to repeat.)
Check the pattern for offset lines
or segments and change the adjust
x Slant Check End
[SelecType]/[Item]
OK
Bad
OK
Bad
Head Adjust Lever A
(in front of B/C heads)
Figure 5-4. B/C Head Skew Adjust Lever
Adjustment Steps
Printing Pattern
lever position if necessary.
[Enter]
Print Adj. Pattern
Revision B
Check other
head/end
adjustment
120