Other/Notes - Epson Stylus Pro 9000 Service Manual

EPSON Stylus Pro 9000
Downloading the data from the PC card to the printer
1. Make sure the access cover is removed from the top of the Upper Paper
Guide, add make sure the Control Panel is attached.
2. Insert the PC card containing the backup data into the PC card slot
connector on the Main Board, and turn on the printer.
3. Make sure the following message appears on the LCD.
Wait:F->M Push:M->F
4. Press any button on the Control Panel to start the download procedure.
Mcard -> Flash
If you wait 15 seconds before you press one of the
Control Panel buttons, the printer will start the backup
procedure instead of the download procedure. This
overwrites data stored in the PC card with data stored
in the Main Board Flash memory.
5. When the download procedure is finished, the following message appears.
End [Success]
6. After making sure the printer is finished, turn off the printer and remove the
PC card.
Adjustment

OTHER/NOTES

If an error occurs during the backup or download procedure, the following
message appears on the LCD.
If you see the message above, one of the following errors has occurred. Using
a different PC card, try the operation again.
Flash memory/ write error
Flash memory/ erase error
PC card/ write error
PC card/ erase error
If using a different PC card does not solve the problem, there is a problem with
the flash memory on the Main Board and a backup is not possible.
Adjustment Steps
Revision B
End [Error]
111