H Top Cover Removal; Epson Stylus Pro - Epson Stylus Pro 9000 Service Manual

EPSON Stylus Pro 9000

H TOP COVER REMOVAL

1. Remove the Maintenance Cover. See "Maintenance Cover Removal" on
page 73.
2. Remove the four screws, CP(W2) M4x12, that secure the left-side lower
mounting bracket and remove the bracket. Repeat for the right-side lower
mounting bracket.
Mounting brackets
(lower)
Figure 4-4. Lower Mounting Bracket Removal
3. Remove the four screws, two silver CP(W2) M3x6 and two silver CP(W2)
M4x6.
Disassembly & Assembly
4. Lift the H Top cover from the rear edge, and carefully tilt it forward, and lift
it away from the printer.
When lifting the H Top Cover off the printer, be careful not
to catch the rear edge of the Cover on the P-Thick sensor
lever which is in the paper path to the right of center. If the
P-Thick sensor is knocked out of position, the printer
cannot properly determine the paper thickness.
CP(W2) M3x6 screws
CP(W2) M4x6 screws
Figure 4-5. H Top Cover Removal
Disassembly Flow
Revision B
74