Panel Settings - Epson EPL-N1600 Service Manual

EPSON EPL-N1600
BUTTONS


OnLine button
Toggles printer ONLINE state on and off. (If printer is in one of the
setup modes, this switch releases the mode and sets the printer to
ONLINE state.)


Form Feed button
If the printer contains data but is not enabled for printing (if Form
Feed lamp is on), this switch causes printer to output printing results
and eject the paper. (This button does not cause ejection if Form
Feed lamp is off.)


Continue button
Clears error (if pressed while Continue LED is blinking). When
printer is in ONLINE state, this button will also clear any warning
display that may appear on the LCD.


SelecType / ALT button
Selects the panel setting mode: OneTouch Mode 1, OneTouch
Mode 2, or SelecType Mode. Also operates as a ALT key. Panel
button operations vary according to the currently selected panel
setting mode.


MENU button
Selects the corresponding OneTouch mode setting listed above this
button, or selects the SelecType menu if in SelecType mode. Press
this button whe the printer is online to enter SelecType mode.
Rev. A


ITEM button
Selects the corresponding OneTouch mode option listed above this
button, or selects the fucntion available within the current menu,
after entering the SelecType mode.


VALUE button
Selects the corresponding OneTouch mode option listed above this
button, or selects the parameter available within the current item,
after entering the Item of the SelecType mode.


ENTER button / Status Sheet print
Selects the corresponding OneTouch mode option listed above this
button, or accepts the setting curretnly shown on the LCD as a new
setting when in SelecType mode.
Press this button twice when the printer is online to print the status
sheet.


RESET (ALT + Conitnue)
Pressing the Continue button while holding down the ALT button will
reset the printer. The LCD will display the message RESET. To
generate a complete reset (warm boot), continue to hold down these
buttons for approximately five seconds after the RESET message
appears; the message will then change to RESET ALL and the
printer will start warm-up processing.
Chapter 1 Product Description
27