Roll Assembly Btr - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.39 Roll Assembly BTR

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Place the BTR Tool under the right end of the BTR shaft, and pry
the end of the shaft off of the Bearing BTR. (See the illustration for
the correct use of the BTR Tool.)
7. Place the BTR Tool under the left end of the BTR shaft, and pry the
left end off of the Bearing BTR. (See the illustration for the correct
use of the BTR Tool.)
8. Lift the Roll Assembly BTR together with the Chute Assembly BTR
out of the Frame.
Do not touch the black sponge rubber roll. Handle the
Roll Assembly BTR only by the metal ends.
9. Slide the Gear BTR off of the end of the Roll Assembly BTR shaft.
10. Pull the Chute Assembly BTR away from the Roll Assembly BTR.
11. Pull the Roll Tracking BTR to slide off of each end of the Roll
Assembly BTR shaft.
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-45. "Roll Assembly BTR" Removal
4-148