Cover Assembly,E - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3 Cover Assembly,E

1. Remove the Duplex Unit if installed.
2. Remove the Cover Side,E. (Section 4.2.1)
3. Remove the Control Assembly Panel (E). (Section 4.2.3)
4. Remove the Cover Assembly MBF.E. (Section 4.2.4)
5. Remove the Tray Assembly MBF.E. (Section 4.2.5)
6. Loosen the two screws that are located at the front of the Cover
Assembly,E.
7. Remove the two screws that are located at the rear of the Cover
Assembly,E.
8. Open the Cover Exit,E
9. Remove the two screws that are located on the top of the Cover
Assembly,E.
10. Lift the Cover off of the Printer Frame pulling the bottom end of the
Cover Assembly,E below the Printer Power Switch away from the
Printer Frame to make the edge of the switch hole in the Cover pass
over the Printer Power Switch (1).
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-6. "Cover Assembly, E" Removal
4-109