EPSON EPL-N1600
4.3.48 PWBA Hotaru
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the screw that secures the Holder Electrical to the Frame
(side).
9. If the Cartridge Assembly EP. (CRU) is still installed, remove it.
10. Locate the access hole to the screw that secures the PWBA Hotaru
to the Chassis Assembly PS. The hole is located immediately in
front of the Fuser Assembly.
11. Remove the screw that is located below the access hole.
12. Slide the Holder Electrical out of the Frame.
13. Disconnect all P/Js from the PWBA Hotaru.
14. Remove the two screws that secure and PWBA Hotaru to the
Holder Electrical and remove the PWBA from the Holder.
Rev. A
Chapter 4
Disassembly and Assembly
Figure 4-54. "PWBA Hotaru" Removal
4-157