Solenoid Exchange - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.16 Solenoid Exchange

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the C258MAIN Board.(Section 4.3.49)
7. Remove the Shield Assembly Bottom (E). (Section 4.3.44)
8. Remove the two screws that secure the Solenoid Exchange
(Direction solenoid) to the Printer Frame.
9. Take the Solenoid out of the Frame, tilting the top of the Solenoid
away from the Frame while pushing in the bottom end of the
Solenoid plunger upward obliquely to disengage the Solenoid
plunger from the forked arm of the Chute Exchange.

Position the SOLENOID EXCHANGE as to locate the
screw holes on your right.

Make sure to engage the solenoid plunger with a falk
arm of the CHUTE EXCHANGE while pushing up the
arm with your finger.
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-22. "Solenoid Exchange" Removal
4-125