Roll Fuser And Heater Quartz; Rev. A - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.36 Roll Fuser and Heater Quartz

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Roll Assembly Exit Out. (Section 4.3.27)
7. Remove the Fuser Assemble. (Section 4.3.31)
8. Turn the Fuser Assembly upside down.
9. Remove the Roll Assembly Exit. (Section 4.3.34)
10. Remove the two screws that secure the ends of the Heater Quartz
to the Fuser Frame.
11. Hold the ends of the Roll Fuser, and lift the Roll Fuser along with the
Heater Quartz, Bearings Heat Roll, and Chute-Exit Heat Roll out of
the Fuser Frame.
12. Hold the metal tabs attached to the ends of the Heater Quartz and
carefully slide the Heater Quartz out of the Roll Fuser.
Do not touch the Heater Quartz with your fingers. Hold
the Heater by the metal tabs that are attached to the
ends of the Heater.

Rev. A

Chapter 4
13. Press the Ring-Rollers out of the grooves and slide them off of the
Roll Fuser.
14. Slide the Bearings Heat Roll off of the Roll Fuser.
Figure 4-42. "Roll-Fuser / Heater Quartz" Removal
Disassembly and Assembly
4-145