Holder Gear Mbf - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.22 Holder Gear MBF

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod, and
Spring Nip Pre-Registration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the Roll Assembly MBF.(Section 4.3.21)
9. Remove the screw that secures the Holder Gear MBF to the Frame
MBF.
10. Press the latch beside the Solenoid arm to release the Holder Gear
MBF.
11. Reach under the Holder and press the spring-loaded lever while you
slide the Holder Gear MBF out of the shaft of the Gear Assembly
MBF.
12. Be careful not to lose the Spring Lever MBF because it is not fixed
to the Holder Gear MBF nor to the Lever MBF .
Rev. A
Chapter 4 Disassembly and Assembly
Figure 4-28. "Holder Gear MBF" Removal
4-131