Actuators Pre-Registration A And B - Epson EPL-N1600 Service Manual

EPSON EPL-N1600

4.3.10 Actuators Pre-Registration A and B

1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod and
Spring Nip Pre-Registration (steps 6 and 7 of PL4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the C258MAIN Board.(Section 4.3.49)
9. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
10. Remove the PWBA Hotaru.(Section 4.3.48)
11. Remove the Chassis Assembly PS.(Section 4.3.46)
12. Remove the Roll Assembly Feed.(Section 4.3.7)
13. Remove the Actuator No Paper.(Section 4.3.8)
14. Remove the Drive Assembly-F/P.(Section 4.3.42)
15. Remove the Drive Assembly Main.(Section 4.3.43)
16. Remove the Drive Assembly.(Section 4.3.3)
17. Remove the Sensor Toner if installed.
18. Remove the Kit Chute Registration Assembly. (Section 4.3.11)
Rev. A
Chapter 4
19. Pull the right end (spring-loaded end) of Actuator Pre-Registration B
(PL3.1.19: one with the longer shaft) out of the retaining opening in
the right mounting post, and slide the Actuator off of the hole in the
left mounting post.
20. Pull the Actuator Pre-Registration A out of the retaining opening in
the mounting posts.
Figure 4-16. "Actuator Pre-Registration A" Removal
Disassembly and Assembly
4-119