Epson EPL-N1600 Service Manual page 94

EPSON EPL-N1600
3.13 DAMAGED PRINTING
Problem
The printed paper is either
wrinkled, creased, or torn.
Rev. A
Suspect Components
The following components are assosiated with
this specific problem. One or more of these
components may have failed partially or
completely. If you can not isolate the problem
using this procedure, replace each components
listed below, one at a time, until the problem
disappears.
• Fuser Assy.
• Paper Cassette
• Paper Path Rolls
Step Action and Question
1 PAPER FEED
• Are the paper cassettes installed
correctly?
• Is the paper loaded into the
cassette correctly?
2 PAPER CONDITION
Is the paper damp?
3 PAPER PATH
Inspect the entire paper path for any
ostructoion or contamination.
Is the paper path free of obstruction
or contamination?
4 PAPER PATH ROLLS
Inspect all rolls along the paper path
for any contamination, wear or
damage.
Are the paper path rolls free of
contamination, wear or damage?
FUSER ASSY.
5
1. Remove the Fuser Assy.
2. Inspect the surface of Roll Fuser
and Roll Press.
Are the surface of rolls free of dirt or
scracthes?
6 IMAGING CARTRIDGE
Install a new Imaging Cartridge.
Is the print image normal?
Chapter 3 Troubleshooting
Yes No
Go to Step 2. Reload the
paper and re-
install the paper
cassette.
Replace with Go to Step 3.
new, dry paper.
Go to Step 4. Clean or
remove the
obstruction in
the paper path.
Go to Step 5. Replace the
damaged or
worn rolls to
new one.
Go to Step 6. Clean or
replace the
rolls.
Go to suspect Problem
component. solved.
96