Link Interlock Switch And Cam Interlock Switch - Epson EPL-N1600 Service Manual

EPSON EPL-N1600
4.3.13 Link Interlock Switch and Cam Interlock
Switch
1. Remove the Cover Side,E. (Section 4.2.1)
2. Remove the Control Assembly Panel (E). (Section 4.2.3)
3. Remove the Cover Assembly MBF.E.(Section 4.2.4)
4. Remove the Tray Assembly MBF.E.(Section 4.2.5)
5. Remove the Cover Assembly,E. (Section 4.3)
6. Remove the Lever Jam Clear, Spring-Hold Rod, Stopper Rod, and
Spring Nip Pre-Registration (steps 6 and 7 of RRP 4.1.1).
7. Remove the Frame Assembly MBF.(Section 4.3.19)
8. Remove the C258MAIN Board.(Section 4.3.49)
9. Remove the Shield Assembly Bottom (E).(Section 4.3.44)
10. Remove the PWBA Hotaru.(Section 4.3.48)
11. Remove the Chassis Assembly PS.(Section 4.3.46)
12. Remove the Drive Assembly-F/P.(Section 4.3.42)
13. Remove the Drive Assembly Main.(Section 4.3.43)
14. Remove the Sensor Toner if installed.
15. Remove the Roll Assembly Feed.(Section 4.3.7)
16. Remove the Actuator No paper.(Section 4.3.8)
17. Remove the Drive Assembly.(Section 4.3.3)
Rev. A
Chapter 4
18. Remove the Kit Chute Registration Assembly. (Section 4.3.11)
19. Pull the Cam Interlock Switch off of the retaining slots.
20. Press down the stopper tab on the Link Interlock Switch and slide
the Link Interlock Switch to the left out of the guide on the Kit Chute
Registration Assembly Kit Chute Registration Assembly.
Figure 4-19. "Link Interlock Switch/Cam Interlock Switch"
Disassembly and Assembly
Removal
4-122